The Core i3-7100 is a cpu manufactured by Intel that was released on January 2017. This model has 2 Kaby Lake-S cores with HyperThreading, runs at 3900 MHz as base frequency and has a a thermal design power of 51 W.
The first Kaby Lake CPU was released in August 2016. It uses a 14 nm process and was the first architecture in breaking the previous tick-tock model. Actually, it is not that different from the preceding Skylake: it has 64kB of L1 cache and 256kB L2 cache per core.
The benchmark in Mode 0 (FPU) measures cpu performance with non-optimized software. It uses the basic µinstructions from the i386 architecture with the i387 floating point unit. This mode is compatible with all CPUs so it's practical to compare very different CPUs
Monothread
Multithread
Test#1 (Integers)
4.01k
8.1k (x2.0)
Test#2 (FP)
16.38k
38.7k (x2.4)
Test#3 (Generic, ZIP)
5.31k
12.69k (x2.4)
Test#1 (Memory)
3.98k
3.76k (x0.9)
TOTAL
29.69k
63.24k (x2.1)
SSE3 optimized benchmark
The benchmark in mode I (SSE) is optimized for the use of SIMD instructions with 128 bits register and the SSE set up to version 3. Nearly every modern CPU has support for this mode.
Monothread
Multithread
Test#1 (Integers)
14.04k
30.09k (x2.1)
Test#2 (FP)
20.55k
47.84k (x2.3)
Test#3 (Generic, ZIP)
5.41k
13.13k (x2.4)
Test#1 (Memory)
3.99k
3.52k (x0.9)
TOTAL
43.99k
94.59k (x2.2)
AVX optimized benchmark
The benchmark in mode II (AVX) is optimized to used 256 bits registers beside the first version of the Advanced Vector Extensions (AVX). The first AVX compatible CPU was released in 2011.
Monothread
Multithread
Test#1 (Integers)
14.41k
30.48k (x2.1)
Test#2 (FP)
22.38k
52.08k (x2.3)
Test#3 (Generic, ZIP)
5.45k
12.97k (x2.4)
Test#1 (Memory)
4.96k
4.56k (x0.9)
TOTAL
47.21k
100.1k (x2.1)
AVX2 optimized benchmark
The benchmark in mode III (AVX2), like AVX1, is optimized to used 256 bits registers beside the second version of the Advanced Vector Extensions (AVX). The first AVX2 compatible CPU was released in 2013.
Monothread performance graphics gives the performance vs time. They are useful to measure the time it takes to the CPU to reach the maximum performance.
Usually, CPU's performance will be steady during these tests but if it has a slow frequency strategy, the first samples will show a lower score.
Test#1 (Integers) [% vs time]
Test#2 (FP) [% vs time]
Test#3 (Generic, ZIP) [% vs time]
Test#1 (Memory) [% vs time]
Multithread performance graph
Multithread graphs measure the performance against a heavy load during certain time.
If CPU's TDP doesn't limit the frequency and the machine is properly cooled, performance should remain steady vs time. Otherwise, the performance score will oscillate or decrease over time.